|20||0,10€||Up to 2,00€|
|50||0,20€||Up to 10,00€|
|100||0,30€||Up to 30,00€|
WARNING: solder it swiftly and with a low as possible temperature, it is not a normal printed circuit board and it could melt if soldered incorrectly.
It allows to simplify and make soldering the two circuits faster, it is much thinner and smaller than normal cables as well.
It has been made with a longer length than strictly necessary to allow fexibility in its use, it should fit in every kind of mod.
It's possible to bend it on itself, twist it and flex it to adapt it to the desired length and for non collinear connections between charger and DNA60.
Please read the datasheet before soldering, it can be downloaded below. A 3D model of the cable is available as well.